Initial Configuration
BenQ TH682ST Projector configuration
Perform a factory reset by doing following in the BenQ TH682ST projector menu:
- Advanced → Reset All Settings → Reset → wait for “Reset Successful” message to appear
Now, make sure these options are selected as follows:
- Source → Quick Auto Search → Off
- Basic → Menu Settings → Reminder → Off
- Basic → Operation Settings → Direct power → Off
- Basic → Operation Settings → Auto Power Off → 15 min
- Basic → Operation Settings → Instant restart → On
- Basic → Background Color → Black
- Basic → Splash Screen → Black
- Advanced → Audio Settings → Volume → 0
- Advanced → Lamp Settings → Lamp Mode → Normal
- Advanced → Baud Rate → 115200
- Advanced → Standby settings → Monitor Out → On
- Advanced → Standby settings → Audio Pass Through → HDMI
Finally, if you find the loud beep sounds signalizing start or shutdown of the projector annoying, you can switch them off by following:
- Advanced → Audio Settings → Power On/Off Ring Tone → Off
Lumitrix indoor
We strongly recommend to let LumiBOX control your projector for you. Should you want to change this behavior, please connect to you LumiBOX WebGUI (please, consult the “Quick WebGUI Overview” section of this guide to learn how to do that) and select one of the following options:
- Settings tab → Control Settings → Projection Control → None (you will have to switch your projector On/Off manually)
- Settings tab → Control Settings → Projection Control → BenQ (LumiBOX will use serial port connection to control BenQ Projector, this is the default for LumiBOX Bundle)
- Settings tab → Control Settings → Projection Control → PJLink (LumiBOX will attempt to control any PJLink compatible projector via LAN cable connection, however, this option is experimental only, as projector manufacturers rarely adhere to the exact specification of the PJLink protocol and use their own implementation instead)